Post by mhackney » Mon Aug 25, 2014 5:56 pm I'm trying to get a new machine operational and everything works except the homing direction. You can disable the homing lockout at startup, configure which axes move first during a homing cycle and in what order, and more. Look for $22 Homing cycle, boolean. https://github.com/notifications/unsubscribe/ANpP3C7aodDQvZKmv_hB5pkF5nGLTV1dks5qLxbDgaJpZM4AnID4 Depending on how many axes you have, enable the right homing cycle. Notice the X and Y arrows representing which way is positive and which way is negative. Located based on switch trigger, rather than release point. Be aware how this will affect your pen. privacy statement. I agree with Tom, disable hard and soft limits, disable homing and try your machine out - $5=0 $20=0 $21=0 $22=0. $0=10 (step pulse, usec) $1=25 (step idle delay, msec) $2=0 (step port invert mask:00000000) $3=2 (dir port invert mask:00000010) thanks. Inches When turned on machine units for jogging is set to "Inches" ; To adjust the X and Y axis step size slide the XY: progress bar. Any config example ? The text was updated successfully, but these errors were encountered: Yes there is a way to do it. hi all im working on my diy cnc and im using arduino uno and GRBL running on it with easydriver 4.4 i prefer to use dual steppers on y axis drive . #define HOMING_SEARCH_CYCLE_0 ((1<